![]() Also, to anyone really familiar with the Unifence, is it normal to have slop in the gizmo that rides along the track until you clamp the fence down? In other words, I can take each side of the part of the fence assembly that rides along the rail in each hand and move it a little either fore or aft. Are there any aftermarket cast (or at least steel that are not concave) wings that would fit this saw, without a whole lot of jerking around? It's 27" deep. I realize these saws are nobody's favorite, but I've got what I've got, and would like to make it work as well as I can. The factory extension wings are crappy stamped steel, with dished out centers, which cause the little round foot the Unifence glides on to to either fall down into the wing, when sliding the fence off the cast iron part of the saw to the right, or you have to help it hop over the lip going the other way, which makes the whole operation tedious and annoying, and far from smooth. ![]() I've installed a Delta Unifence system on my older Craftsman 113XXX table saw. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |